Table of Contents
Product Overview
NOTE3 is a general GNSS module based on the UBLOX M9N module, which has the advantages of small size, high sensitivity, and strong star search signal ability.
Product Features
- Used the UBLOX NEO-M9N positioning module;
- Supports receiving satellite signals from four GNSS systems at same time (GPS, Galileo, GLONASS, BeiDou);
- Equipped with an electronic compass sensor chip, it can measure the magnetic heading of the device;
- Built-in RGB three-color LED light, which can indicate the status information of the flight controller;
- Built-in coin cell battery, support hot start;
Procurement Method
Specification table
| Specification item | Parameter value |
|---|---|
| GNSS Module | ublox NEO-M9N |
| Compass | IST8310, I2C |
| RGB sensor | NCP5623, I2C |
| Satellite systems | Beidou, GPS, Galileo, Glonass |
| Frequency band | Beidou: B1l GPS: L1C/A GLONASS: L10F GALILEO: E1B/C QZSS: L1C/A SBAS L1 |
| Navigation rate | PVT 25Hz(MAX) |
| Satellites | 32+ |
| Positioning | GNSS: 1.5m + 1ppm CEP |
| Speed accuracy | 0.05m/s |
| Capture satellite | Cold start: <24s Hot start: <1s |
| Antenna gain | 5.5dBi |
| Flight control platform | Ardupilot, PX4 |
| Physical Interface | JST GH1.25 6Pin/10Pin |
| Communication Interface | UART, UBX or NMEA protocol |
| Anti-interference | SAW+LNA |
| Input voltage | 4.5~5.5V |
| Working current | 60mA(5V) |
| Line length | 25cm |
| Operating temperature | -40℃ to 85℃ |
| Size | 60mm(diameter) 16mm(height) |
| Weight | 46.9g |
Interface
Dimensions
