NOTE 5 – CAN M10 GNSS module

Product Overview

NOTE5 is a general GNSS module based on the latest UBLOX M10 module, with lower power consumption and stronger star search capabilities.

Product Features

  • Used the UBLOX M10 positioning module;
  • Concurrent reception of four constellations at same time (GPS, Galileo, GLONASS, BeiDou);
  • Built-in electronic compass sensor chip, which can measure the magnetic heading of the drone;
  • Built-in RGB three-color LED light, which can indicate the status information of the flight controller;
  • Built-in coin cell battery, support hot start;

Procurement Method

Contact us

Specification table

Specification itemParameter value
GNSS Chipu-blox m10
Frequency bandGPS L1 C/A, QZSS L1 C/A/S, GLONASS L10F,
Galileo E1B/C, SBAS L1 C/A: WAAS, EGNOS, MSAS, GAGAN
Satellite systemsGPS, Galileo, GLONASS, QZSS
Satellites32+
Flight control platformSupport Ardupilot, PX4
Operating voltage4.5~5.5V
Operating current50mA(5V)
ProcessorCortex-M4F, 240MHz
RTOSThreadx
Positioning accuracy1.5m CEP
Speed accuracy0.05m/s
Communication InterfaceDroneCAN
BuzzerSupport
RGB sensorSupport
CompassIST8310
Capture satelliteCold start: ≤28s
Hot start: ≤1s
Navigation rate5Hz(Default), 10Hz(Four GNSS), 25 Hz(Single GNSS)
Operating temperature-40℃ to 85℃
Physical InterfaceJST GH1.25 6Pin/10Pin
Line length25cm
Size60mm(diameter)
16mm(height)
Weight45g

Interface