Table of Contents
Product Overview
NOTE 2 is a cost-effective general GNSS module with the advantages of small size, low cost and high sensitivity.
Product Features
- Used the UBLOX NEO-M8N positioning module;
- Supports receiving satellite signals from four GNSS systems (GPS, Galileo, GLONASS, BeiDou);
- Equipped with an electronic compass sensor chip, it can measure the magnetic heading of the device;
- Built-in RGB three-color LED light, which can indicate the status information of the flight controller;
- Built-in coin cell battery, support hot start;
Procurement Method
Specification table
| Specification item | Parameter value |
|---|---|
| GNSS chip module | U-blox NEO-M8N |
| GNSS bands | GPS L1C/A, SBAS L1C/A, QZSS L1C/A, QZSS L1 SAIF, GLONASS L1OF, BeiDou B1I, Galileo E1B/C |
| Satellite system | Supports concurrent two-satellite systems(GPS+GLONASS) |
| Number of satellites | 20+ |
| Open source flight controller | Ardupilot & PX4 |
| Operating voltage | 4.5V – 5.5V |
| Operating current | 50mA(5V voltage) |
| Horizontal positioning accuracy | 2.5m |
| GNSS chip interface | Serial communication NMEA or UBLOX protocol |
| RGB driver IC | I2C communication NCP5623 |
| Electronic compass sensor | I2C communication IST8310 |
| Connector model | JST GH1.25 6Pin/10Pin |
| Cold start time | 26 seconds |
| Hot start time | 1 seconds |
| Navigation update frequency | Default 5Hz Max 10Hz |
| Operating temperature | -20℃ – +60℃ |
| Wire length | 25cm |
| Dimensions | Diameter 60mm Thickness 16mm |
| Weight | 42.2g |
Dimensions
Interface
